M1 G2 Using the Projector

Starting the Projector

1. Ensure the projector is connected to a power source or that the battery has sufficient charge.
2. Open the Smart Stand by moving its lens cover down.
3. Move the Smart Stand to your desired viewing angle.

First Time Activation

If the projector is activated for the first time, you will need to select your Preferred Language, Projection Orientation, and Network Settings. Follow the on-screen instructions using the OK and Up/Down/Left/Right buttons on the remote control. When the "Finish screen" appears, this indicates the projector is ready to use.

Preferred Language

Select the desired language and press OK to confirm the selection.

Projection Orientation

Select the preferred projection orientation and press OK to confirm the selection.

Adjusting the Projector's Height and Projection Angle

The projector is equipped with one (1) Smart Stand. Adjusting the stand will change the projector’s height and the vertical projection angle. Carefully adjust the stand to fine tune the projected image’s position.

NOTE: If the projector is not placed on a flat surface or the screen and the projector are not perpendicular to each other, the projected image can become trapezoidal. However, the “Auto Vertical Keystone” function will correct the issue automatically.

Adjusting the Focus

To adjust the image focus of the on-screen image, slowly move the focus ring upwards or downwards.

Shutting Down the Projector

1. Press and hold the Power button for three (3) seconds on the projector, or press the Power button on the remote control.
2. Pressing the Power button on the remote control will result in the following message:

3. Press the Up/Down buttons on the remote control to select Turn Off and press OK on the remote control.

NOTE: When not in use, please press the Power button to power off. If only using the Power button on the remote control to power off, the projector will enter standby mode and the embedded battery will still consume some power.