VB-VIS-003 Initial Setup

Setting Up the Document Camera

1. Lift the device by pushing through the opening at the Base Plate.

2. Press against the Base Plate and pull up on the Camera Arm to extend it. Then, rotate the Camera Head.

Note: Do not turn the Camera Head in the wrong direction.

3. Adjust the Camera Arm to change the height and position of the camera. Fully extend the Camera Arm to capture the maximum shooting area of A3 at output, 2048 x 1536 4:3 mode.

4. Press the Autofocus Button once to focus the camera. Press and hold the Flip Button to adjust image orientation (if applicable).

5. If the environment is dark, press the LED Light Button to turn on the LED light.