• Print Print

VB-CAM-201 Making Connections

From ViewSonic Documentation
Jump to: navigation, search
VB-CAM-201 Making Connections
Introduction
Initial Setup
Making Connections
Using the Camera
Network
Appendix
Regulatory and Service Information

Connecting to Power

Connecting External Devices

HDMI Connection

USB Connection

Bluetooth Connection

Host Mode

Host 1

Host 2

Client Mode

Remote Control Pairing

  1. Connect the power supply to the camera and power it on.
  2. Clear the paired status of the remote control:
  • Press the Menu Button and OK buttons at the same time, keep pressing until the remote control indicator shows a steady red light, release the buttons to successfully clear the paired remote control.
  1. Trigger the camera to enter the remote control pairing mode:
  • Press the Reset button on the camera, and the camera’s LED light will switch to blue. This indicates it has entered pairing mode.
NOTE: Each time you enter pairing mode, there is only 15 seconds of operation time. After which, the pairing mode will automatically end.
  1. Start Pairing:
  • Using a cleared remote control, press and hold the Menu Button, and wait for the pairing to complete.
  • When the normal pairing is successful, the camera’s LED light will be flashing blue.
  • If the pairing fails, please repeat steps 2~4 until the pairing is successful.
NOTE: The remote control has been paired with the VB-CAM-201 at the factory, and it can be used normally without any special operation.
Retrieved from "https://manuals.viewsonic.com/index.php?title=VB-CAM-201_Making_Connections&oldid=19894"