• Print Print

MA1014L MA1214L Making Connections

From ViewSonic Documentation
Revision as of 06:11, 8 August 2022 by Rob.vsi (talk | contribs) (Created page with "<noinclude> __NOTOC__ {{Sticky_Menu_Pen_Display_MA14 |1=MA1014L_MA1214L_Introduction |2=MA1014L_MA1214L_Making_Connections |3=MA1014L_MA1214L_Using_the_Display |4=MA1014L_MA12...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
MA1014L MA1214L Making Connections
Introduction
Making Connections
Setting the Display Area
Pen Input Area Mapping
Device Features
Specifications
Regulatory and Service Information
Safety Precautions
Troubleshooting
Maintenance

Installing Drivers and Software

System Requirements:
Operating system: Windows XP/7/8/10 (32/64 bit)
PC I/O: USB 2.0/above

Before connecting and using the pen display, it is necessary to install the below software. The software can be downloaded at:
https://www.viewsonicglobal.com/q/MA1014L
https://www.viewsonicglobal.com/q/MA1214L

DisplayLink Driver

Open the DisplayLink installation file and install the driver.

NOTE: DisplayLink Driver can be installed through Windows Update.

Pen Display Driver

Pen Display Manager can be used to map the active area and adjust the feel of the pen.

  1. Open the ViewSign Console installation file and install the driver.
  2. After the installation completes, you will need to restart the computer.
NOTE: For further ViewSign Console information, please visit: https://manuals.viewsonic.com/ViewSign_Software

Connecting the Pen Display

  1. Turn the device over so the bottom side is facing up.
  2. Plug the USB Type A end of the USB cable into the USB Port on the device.
  3. Connect the Main USB A cable to the computer. The Secondary USB A cable can be connected to a fully powered USB port on the computer.
Retrieved from "https://manuals.viewsonic.com/index.php?title=MA1014L_MA1214L_Making_Connections&oldid=20565"