• Print Print

VPC-A31-O1 Initial Setup: Difference between revisions

From ViewSonic Documentation
Jump to: navigation, search
← Older edit
No edit summary
 
(One intermediate revision by the same user not shown)
Line 5: Line 5:
|3=VPC-A31-O1_Making_Connections
|3=VPC-A31-O1_Making_Connections
|4=VPC-A31-O1_Using_the_Device
|4=VPC-A31-O1_Using_the_Device
|5=VPC-A31-O1_Appendix
|5=VPC-A31-O1_Settings
|6=VPC-A31-O1_Regulatory_and_Service_Information
|6=VPC-A31-O1_Pre-installed_Applications_and_Settings
|7=VPC-A31-O1_Appendix
|8=VPC-A31-O1_Regulatory_and_Service_Information
}}
}}
</noinclude>
</noinclude>

Latest revision as of 02:28, 9 November 2023

VPC-A31-O1 Initial Setup
Introduction
Initial Setup
Making Connections
Using the Device
Settings
Pre-installed Applications and Settings
Appendix
Regulatory and Service Information

Installing the VPC-A31-O1

  1. Remove the slot-in PC cover of the display.
  2. Using the handle of the VPC-A31-O1, carefully insert it into the PC slot of the display.
    3. NOTE:
    • Ensure the handle and vents of the VPC-A31-01 are facing outwards.
    • The right installation direction is to avoid damage to the OPS terminal and maintain proper ventilation.
  3. Secure the VPC-A31-O1 to the display with the two (2) included screws.
    4. NOTE:
    • Please note that the three (3) antennas must be installed on the VPCA31-O1.
    • Please pay attention to the installation direction of the VPC-A31-O1, with the vents facing outwards to avoid damage.
    • The VPC-A31-O1 does not support hot swapping. When removing the device, turn off the power supply for both the display and VPC-A31-O1 first.
Retrieved from "https://manuals.viewsonic.com/index.php?title=VPC-A31-O1_Initial_Setup&oldid=32420"