PD1213 PD1213T Making Connections

Installing Drivers and Software

System Requirements:
Operating system: Windows XP/7/8/10 (32/64 bit)
PC I/O: USB 2.0/above

Before connecting and using the pen display, it is necessary to install the below drivers and software. The drivers and software can be downloaded at:
http://www.viewsonicglobal.com/q/PD1213

DisplayLink Driver

Open the DisplayLink installation file and install the driver.

NOTE: DisplayLink Driver can be installed through Windows Update.

Pen Display Driver

Pen Display Manager can be used to map the active area and adjust the feel of the pen.

1. Open the ViewSign Console installation file and install the driver.
2. After the installation completes, you will need to restart the computer.

NOTE: For further ViewSign Console information, please visit: https://manuals.viewsonic.com/ViewSign_Software

Connecting the Pen Display

1. Turn the device over so the bottom side is facing up.

2. Plug the Micro USB end of the USB cable into the Micro USB Port on the device.

3. Connect the Main USB A cable to the computer. The Secondary USB A cable can be connected to a fully powered USB port on the computer, or to an AC outlet using the supplied power adapter.

NOTE: When connecting the USB cable directly to the computer, the screen of the tablet may flicker if the computer power is insufficient. In this case, please connect the secondary USB A cable (shown in red) to the power adapter and plug the adapter into an AC outlet to ensure that there is enough power for the pen display.