LX700-4K RGB Remote Control

Overview

Number	Button		Description
1	Power ON		Turns the projector ON
2	Power OFF		Turns the projector OFF
3	AV Mute		Hides the screen picture and volume mute.
4	Zoom In		Increases the projected image size.
5	Zoom Out		Reduces the projected image size.
6	Contrast		Displays the contrast selection bar.
7	Display Mode		Displays the display mode selection bar.
8	Brightness		Displays the brightness selection bar.
9	Aspect		Displays the aspect ratio selection bar.
10	Keystone		Manually correct distorted images.
11	Brightness Mode		Displays the brightness mode selection bar.
12	Freeze		Freeze the projected image.
13	Mute		Mute/unmute.
14	▲/Volume Increase		Navigate upwards. Increase the volume level.
15	Enter		Confirms the selection.
16	◄/Source		Navigate to the left. Displays the input source selection bar.
17	►/Auto Sync		Navigate to the right. Automatically determines the best picture timings for the displayed image.
18	▼/Volume Decrease		Navigate downwards. Decrease the volume level.
19	Menu/Exit		Turns the On-Screen Display (OSD) Menu On or Off. Go back to a previous OSD Menu. Exit and Save menu settings.
20	HDMI 1		Select the HDMI 1 input source.
21	HDMI 2		Select the HDMI 2 input source.

Remote Control - Receiver Range

IR Receiver Location

To ensure proper function of the remote control follow the steps below:

1. The remote control must be held at an angle within 30° perpendicular to the projector’s IR remote control sensor(s).
2. The distance between the remote control and the sensor(s) should not exceed 8 m (26 ft.).

NOTE: Refer to the illustration for the location of the infrared (IR) remote control sensor(s).

Replacing the Batteries

1. Remove the battery cover from the bottom of the remote control by pressing the finger grip and sliding it across.
2. Remove any existing batteries (if necessary) and install two AAA batteries.

NOTE: Observe the battery’s polarities as indicated.

3. Replace the battery cover by aligning it with the base and pushing it back into position.


NOTE:

• Avoid leaving the remote control and batteries in excessive heat or a humid environment.
• Replace only with the same or equivalent type recommended by the battery manufacturer.
• If the battery is drained or if you will not be using the remote control for an extended period of time, remove the battery to avoid damage to the remote control.
• Dispose of used batteries according to the manufacturer’s instructions and local environment regulations for your region.