![Print](INVALID-TITLE:<span style="margin-right:10px;"></span><span class="d-none d-md-inline"><span id="t-print" style="position: relative;bottom:2px; left:1%; z-index:9999; padding:0; margin:0;">[[File:Icon_Print.svg|Print|1px|link=http://localhost/stage/tango/index.php?title=VP3481_Initial_Setup&printable=yes]]</span></span>
<span class="d-none d-md-inline"><span id="t-print" style="position: relative;bottom:2px; left:1%; z-index:9999; padding:0; margin:0;">[[File:Icon_Print.svg|Print|30px|link=http://localhost/stage/tango/index.php?title=VP3481_Initial_Setup&printable=yes]]</span></span>
[[Category:Template]]
[[Category:Archive]]){kind=small}
VP3481 Initial Setup: Difference between revisions
From ViewSonic Documentation
Created page with "<noinclude> {{Sticky_Menu |1=VP3481_Introduction |2=VP3481_Initial_Setup |3=VP3481_Connecting_Power_and_Devices |4=VP3481_Adjusting_the_Viewing_Angle |5=VP3481_Quick_Menu |6=V..." |
No edit summary |
||
| Line 57: | Line 57: | ||
<noinclude>=[[Monitor_Security_Slot| Using the Security Slot]]=</noinclude> | <noinclude>=[[Monitor_Security_Slot| Using the Security Slot]]=</noinclude> | ||
<noinclude> | |||
==Media== | |||
<youtube>https://www.youtube.com/watch?v=v82WONbjbRM</youtube> | |||
</noinclude> | |||
[[Category:VP3481]] | [[Category:VP3481]] | ||
[[Category:VP Series]] | [[Category:VP Series]] | ||
Revision as of 03:52, 22 May 2020
Stand Installation
- Place the monitor on a flat, stable surface with the screen facing down.
- Align and slide the upper hooks of the stand into the stand mounting slots.
- Lift the device into its upright position on a flat stable surface.
-
Align the hooks -
Lift into an upright position
Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.
Wall Mounting
Refer to the table below for the standard dimensions for wall mount kits.
For use only with a UL certified wall mount kit/bracket. To obtain a wall-mounting kit or height adjustment base, contact ViewSonic® or your local dealer.
| Maximum Loading | Hole Pattern (W x H) | Interface Pad (W x H x D) | Pad Hole | Screw Specification & Quantity |
|---|---|---|---|---|
| 14 kg | 100 x 100 mm | 115 x 115 x 2.6 mm | Ø 5 mm | M4 x 10 mm - 4 pieces |
- Turn off the device and disconnect all cables.
- Place the device on a flat, stable surface with the screen facing down.
- Pull down slightly to disengage the hooks. Then remove the stand.
- Attach the mounting bracket to the VESA mounting holes at the rear of the monitor. Then secure it with four (4) screws (M4 x 10 mm).
- Follow the instructions that come with the wall mounting kit to mount the monitor onto the wall.
-
Disengage the hooks -
VESA mounting points
Using the Security Slot
Media