ViewBoard Cast Button Pairing

Windows PC and MacBook Pairing

Figure 1 VB-WPS-001

Figure 2 VB-WPS-003

1. Plug-in the ViewBoard® Cast Button into your Windows PC or MacBook to pair.
   • For VB-WPS-001: Please plug-in to the USB Type C port (Figure 1).
   • For VB-WPS-003: Please plug-in to both the HDMI out and USB Type A ports (Figure 2).
2. If it is the first time to pair the ViewBoard® Cast Button with your Windows PC, please double click “ViewBoard Cast.exe” in: PC > CD Drive > ViewBoard Cast.

   Note: If running on a MacBook, please enter the user password to access the application installation permission.

3. For PC, with the application installed, ViewBoard® Cast will launch automatically after the ViewBoard® Cast Button is plugged into the PC.
4. The pairing dialogue box will pop up on your PC. Please enter the Network Name, Password, and the vCastReceiver IP address shown on the IFP/CDE device home screen.
5. Click OK to complete the pairing of the ViewBoard® Cast Button and the IFP/CDE device.



6. Remove the ViewBoard® Cast Button and then plug it in again to start sharing



7. If the ViewBoard® Cast Button has been paired, and you would like to pair it with another IFP/CDE device, please click the “Pairing-Switch Button” at the bottom right corner.



8. Re-enter the network information to re-pair the ViewBoard® Cast Button.



9. After the ViewBoard® Cast Button is re-paired, please remove it and plug it in again to start sharing.

ViewBoard IFP/CDE Pairing

You can also plug-in the ViewBoard Cast Button into IFP/CDE device to pair if the IFP/CDE device is connected to a LAN (Ethernet cable).

For VB-WPS-001:

1. Attach the USB Type C to USB Type A adapter to the VB-WPS-001 ViewBoard® Cast Button



2. Then plug the ViewBoard® Cast Button into the IFP/CDE device’s USB port for pairing.

   Note: If running on a MacBook, please enter the user password to access the application installation permission.

For VB-WPS-003:

1. Plug the USB Type A cable into the IFP/CDE device’s USB port for pairing.
2. A “Pairing” dialogue box will appear.
3. Enter the Network Name and Password, then select Save to pair.