![Print](INVALID-TITLE:<span style="margin-right:10px;"></span><span class="nomobile"><span id="t-print" style="position: relative;bottom:2px; left:1%; z-index:9999; padding:0; margin:0;">[[File:Icon_Print.svg|Print|1px|link=http://localhost/stage/tango/index.php?title=VX2716_Initial_Setup&printable=yes]]</span></span>
<span class="nomobile"><span id="t-print" style="position: relative;bottom:2px; left:1%; z-index:9999; padding:0; margin:0;">[[File:Icon_Print.svg|Print|30px|link=http://localhost/stage/tango/index.php?title=VX2716_Initial_Setup&printable=yes]]</span></span>
[[Category:Template]]
[[Category:Archive]]){kind=small}
VX2716 Initial Setup: Difference between revisions
From ViewSonic Documentation
Created page with "<noinclude> {{Sticky_Menu_Monitor_2.1_SU |1=VX2716_Introduction |2=VX2716_Initial_Setup |3=VX2716_Connecting_Power_and_Devices |4=VX2716_Adjusting_the_Viewing_Angle |5=VX2716_..." |
|||
| Line 14: | Line 14: | ||
</noinclude> | </noinclude> | ||
=Stand Installation= | =Stand Installation= | ||
<div class="res-img">[[File: | <div class="res-img">[[File:VX2716_Stand_Installation.png|350px]]</div> | ||
<br /> | <br /> | ||
:{{Note-yellow|Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.}} | :{{Note-yellow|Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.}} | ||
Revision as of 07:47, 15 April 2022
Stand Installation
Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.
Wall Mounting
Refer to the table below for the standard dimensions for wall mount kits.
For use only with a UL certified wall mount kit/bracket. To obtain a wall-mounting kit or height adjustment base, contact ViewSonic® or your local dealer.
| Maximum Loading | Hole Pattern (W x H) | Interface Pad (W x H x D) | Pad Hole | Screw Specification & Quantity |
|---|---|---|---|---|
| 14 kg | 100 x 100 mm | 115 x 115 x 2.6 mm | Ø 5 mm | M4 x 10 mm - 4 pieces |
- Turn off the device and disconnect all cables.
- Place the device on a flat, stable surface with the scree facing down.
- Remove the stand.
- Attach the mounting bracket to the VESA mounting holes at the rear of the monitor. Then secure it with four (4) screws (M4 x 10 mm).
- Follow the instructions that come with the wall mounting kit to mount the monitor onto the wall.
