XG2536 Initial Setup
Installing the Stand
- Note: Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.
Removing the Stand and Mounting the Monitor
Refer to the table below for the standard dimensions for wall mount kits.
- Note: For use only with a UL certified wall mount kit/bracket. To obtain a wall-mounting kit or height adjustment base, contact ViewSonic® or your local dealer.
| Maximum Loading | Hole Pattern (W x H) | Interface Pad (W x H x D) | Pad Hole | Screw Specification | Quantity |
|---|---|---|---|---|---|
| 14 kg | 75 x 75 mm | N/A | Ø 5 mm | M4 x 10 mm | 4 screws |
- Turn off the monitor and disconnect all cables
- Place the device on a flat, stable surface with the screen facing down.
-
Remove the stand.
-
Attach the mounting bracket to the VESA mounting holes at the rear of the monitor. Then secure it with four screws (M4 x 10 mm).
- Follow the instructions that come with the wall mounting kit to mount the monitor.
