TD2423d Connecting Power and Devices

    From ViewSonic User Guide Database

    Connecting to Power

    Connecting to Power
    1. Connect the power cord to the AC IN jack at the rear of the device.
    2. Connect the power cord plug to a power outlet.

    Connecting External Devices

    Note: To connect the monitor to an external device (PC, laptop…etc.), please use one of the included video cables for your application and connect it to both terminals.

    HDMI

    Connect one end of an HDMI cable to the HDMI port of your monitor. Then connect the other end of the cable to the HDMI port of your computer.

    NOTE: The monitor is equipped with one HDMI 1.4 port.

    DisplayPort

    Connect one end of a DisplayPort cable to the DisplayPort port. Then connect the other end of the cable to the DisplayPort or mini DP port of your computer.

    NOTE: To connect the monitor to the Thunderbolt port (v. 1&2) on your Mac, connect the mini DP end of the “mini DP to DisplayPort cable” to the Thunderbolt output of your Mac. Then connect the other end of the cable to the DisplayPort of the monitor.

    VGA

    Connect one end of a VGA cable to the VGA port. Then connect the other end of the cable to the VGA port of your computer.

    USB

    Connect one end of a USB cable to a USB port of the monitor. Then connect the other end of the cable to a USB port of your computer.

    USB Number Description
    Type A Two (2) Connection for your Type A peripheral device(s) (e.g. storage device).
    NOTE: To activate the USB Type A port, ensure your computer is also connected to the monitor’s USB Type B port.
    Type B One (1) Connect the USB Type B male cable (square with 2 cut corners) to this port, and then connect the other end of the cable to the USB downstream port of your computer.

    Audio

    Plug an audio cable into the Audio In/Audio Out port of the monitor. Plug the other end into your computer (Audio In) or ear-/headphones (Audio Out).

    NOTE: The monitor is also equipped with dual speakers.

    Touch Function Control

    Before using the touch function, ensure the USB Type B to Type A cable is connected to your computer and the Windows operating system is running.

    TD2223 Touch Control.svg

    When using the touch function, please note:

    • The touch function may need about five (5) seconds to resume if the USB cable is removed and plugged in again, or the computer resumes from Sleep Mode.
    • The touchscreen can only detect up to ten (10) fingers simultaneously.
    • If the Windows’ cursor does not accurately follow your finger when you touch the screen, do the following:
    1. Open: Control Panel > Hardware and Sound >Tablet PC Settings
    2. Select Calibration.
    3. Follow the instructions to recalibrate your screen.

    Touch Accuracy

    • Touch accuracy is ± 2 mm over 90% of the touch active area located in the middle.
    • Touch size at 10% of the edge area is ≥ 8 mm (as illustrated below), the area at the edges without black ink might not support any touch.
    TD2223 Touch Accuracy.svg
    • It is requested to use a spherical tip stylus with a minimum diameter of 3 mm in 90% of the touch active area.
    • It is requested to use a spherical tip stylus with a minimum diameter of 8 mm in 10% of the edge area.