PD0711 Making Connections

    From ViewSonic User Guide Database
    PD0711 Making Connections
    Introduction
    Making Connections
    Adjusting the Viewing Angle
    Using the Display
    Setting the Display Area
    Pen Input Area Mapping
    Specifications
    Regulatory and Service Information
    Safety Precautions
    Troubleshooting
    Maintenance

    Installing Drivers and Software

    System Requirements:
    Operating system: Windows XP/7/8/10 (32/64 bit)
    PC I/O: USB 2.0/above

    Before connecting and using the pen display, it is necessary to install the below drivers and software. The drivers and software can be downloaded at:
    http://www.viewsonicglobal.com/q/PD0711

    PD1013 PD1013T Driver Software.png

    DisplayLink Driver

    Open the DisplayLink installation file and install the driver.

    DisplayLink 1.png
    DisplayLink 2.png
    NOTE: DisplayLink Driver can be installed through Windows Update.

    Pen Display Driver

    Pen Display Manager can be used to map the active area and adjust the feel of the pen.

    1. Open the ViewSign Console installation file and install the driver.
    2. After the installation completes, you will need to restart the computer.
    Pen Display Driver.png
    NOTE: For further ViewSign Console information, please visit: https://manuals.viewsonic.com/ViewSign_Software

    Connecting the Pen Display

    1. Turn the device over so the bottom side is facing up.
      2. PD0711 Connection 1.png
    2. Plug the USB Type A end of the USB cable into the USB Port on the device.
      3. PD0711 Connection 2.png
    3. Connect the Main USB A cable to the computer. The Secondary USB A cable can be connected to a fully powered USB port on the computer.
      4. PD0711 Connection 3.png
    Retrieved from "https://manuals.viewsonic.com/index.php?title=PD0711_Making_Connections&oldid=16264"