• Print Print

PD0711 Making Connections: Difference between revisions

From ViewSonic Documentation
Jump to: navigation, search
← Older editNewer edit →
Line 13: Line 13:
=Installing Drivers and Software=
=Installing Drivers and Software=
'''System Requirements:'''<br />
'''System Requirements:'''<br />
Operating system: Windows XP/7/8/10 (32/64 bit)
Operating system: Windows XP/7/8/10 (32/64 bit)<br />
PC I/O: USB 2.0/above
PC I/O: USB 2.0/above


Revision as of 06:21, 8 November 2021

PD0711 Making Connections
Introduction
Making Connections
Adjusting the Viewing Angle
Using the Display
Setting the Display Area
Pen Input Area Mapping
Specifications
Regulatory and Service Information
Safety Precautions
Troubleshooting
Maintenance

Installing Drivers and Software

System Requirements:
Operating system: Windows XP/7/8/10 (32/64 bit)
PC I/O: USB 2.0/above

Before connecting and using the pen display, it is necessary to install the below drivers and software. The drivers and software can be downloaded at:
http://www.viewsonicglobal.com/q/PD0711

DisplayLink Driver

Open the DisplayLink installation file and install the driver.

NOTE: DisplayLink Driver can be installed through Windows Update.

Pen Display Driver

  1. Open the ViewSign Console installation file and install the driver.
  2. After the installation completes, you will need to restart the computer.
NOTE: For further ViewSign Console information, please visit: https://manuals.viewsonic.com/ViewSign_Software

Connecting the Pen Display

  1. Turn the device over so the bottom side is facing up.
  2. Plug the USB Type A end of the USB cable into the USB Port on the device.
  3. Connect the Main USB A cable to the computer. The Secondary USB A cable can be connected to a fully powered USB port on the computer.
Retrieved from "https://manuals.viewsonic.com/index.php?title=PD0711_Making_Connections&oldid=16262"