VG2208A Initial Setup

Before Installing the Stand

Please follow the guidelines below when handling the monitor stand.

Note: Please make sure that the stand is firmly attached to the monitor before raising it upright, and then remove the bolt.

Stand Installation

Note: Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.

Wall Mounting

Refer to the table below for the standard dimensions for mounting kits.

Note:

• For use only with a UL certified mounting kit/bracket. To obtain a wall mounting kit or height adjustment base, contact ViewSonic® or your local dealer.
• Mounting kits are sold separately.

Maximum Loading	Hole Pattern (W x H)	Interface Pad (W x H x D)	Pad Hole	Screw Specification	Screw Quantity
14 kg	100 x 100 mm	N/A	Ø 5 mm	M4 x 10 mm	4 screws

1. Turn off the device and disconnect all cables.
2. Place the device on a flat, stable surface with the screen facing down.

3. Remove the monitor stand.

   

4. Attach the mounting bracket to the VESA mounting holes at the rear of the device. Then secure it with four screws (M4 x 10 mm).

   
5. Follow the instructions that come with the wall mounting kit to mount the monitor.

Using the Security Slot

Please see Using the Security Slot.