VB-PEN-007 Initial Setup

Charging the AirPen (VB-PEN-007)

Note: Fully charge the AirPen (VB-PEN-007) before its first use.

1. Connect the USB Type C end of the included USB cable to the Charging Port of the AirPen (VB-PEN-007).
2. Then connect the other end, the USB Type A, of the cable to a USB Type A port of a display or other power delivering device.
3. When charging, the LED Indicator will be a steady red. When fully charged, the VB-PEN-007 can provide four (4) hours of use.
Note: A short, 10 minute charge can provide one (1) hour of use.

Powering On and Pairing the AirPen (VB-PEN-007)

1. Plug the USB Receiver into a USB Type A port of a display device.

2. Press and hold the AirPen's (VB-PEN-007) Power Button for three (3) seconds to begin pairing.
Note: When in pairing mode, the LED Indicator will be flashing blue.

3. After successfully powering on and pairing the VB-PEN-007, the LED Indicator will be a steady blue.

Re-Pairing the AirPen (VB-PEN-007)

If the AirPen (VB-PEN-007) needs to be re-paired, please follow the steps below:

1. Remove the USB Receiver from the display device.

2. Press and hold both the Volume Up and Volume Down buttons on the AirPen (VB-PEN-007) for three (3) seconds to enter pairing mode.
Note: When in pairing mode, the LED Indicator will be flashing blue.

3. Plug the USB Receiver into a USB Type A port of the display device.

4. When paired successfully, the LED Indicator will be a steady blue.