• Print Print

VB-PEN-007 Initial Setup: Difference between revisions

From ViewSonic Documentation
Jump to: navigation, search
← Older editNewer edit →
Line 18: Line 18:
=Powering On and Pairing the AirPen (VB-PEN-007)=
=Powering On and Pairing the AirPen (VB-PEN-007)=
<ol><li>Plug the USB Receiver into a USB Type A port of a display device.</li>
<ol><li>Plug the USB Receiver into a USB Type A port of a display device.</li>
<div class="res-img">[[File:VB-PEN-007_Plug_USB_Receiver.png|Plug in the USB Receiver|400px]]</div>
<div class="res-img">[[File:VB-PEN-007_Plug_USB_Receiver.png|Plug in the USB Receiver|250px]]</div>
<li>Press and hold the AirPen's (VB-PEN-007) '''Power Button''' for three (3) seconds to begin pairing.</li>
<li>Press and hold the AirPen's (VB-PEN-007) '''Power Button''' for three (3) seconds to begin pairing.</li>
{{Note|When in pairing mode, the '''LED Indicator''' will be flashing blue.}}
{{Note|When in pairing mode, the '''LED Indicator''' will be flashing blue.}}
<div class="res-img">[[File:VB-PEN-007_Press_and_Hold_Power.png|Press and Hold the Power Button|400px]]</div>
<div class="res-img">[[File:VB-PEN-007_Press_and_Hold_Power.png|Press and Hold the Power Button|350px]]</div>
<li>After successfully powering on and pairing the VB-PEN-007, the LED Indicator will be a steady blue.</li></ol>
<li>After successfully powering on and pairing the VB-PEN-007, the LED Indicator will be a steady blue.</li></ol>


Revision as of 02:55, 4 January 2024

VB-PEN-007 Initial Setup
Introduction
Initial Setup
Using the Pen
Specifications
Regulatory and Service Information

Charging the AirPen (VB-PEN-007)

Note: Fully charge the AirPen (VB-PEN-007) before its first use.
Charging the Pen
  1. Connect the USB Type C end of the included USB cable to the Charging Port of the AirPen (VB-PEN-007).
  2. Then connect the other end, the USB Type A, of the cable to a USB Type A port of a display or other power delivering device.
  3. When charging, the LED Indicator will be a steady red. When fully charged, the VB-PEN-007 can provide four (4) hours of use.
    4. Note: A short, 10 minute charge can provide one (1) hour of use.

Powering On and Pairing the AirPen (VB-PEN-007)

  1. Plug the USB Receiver into a USB Type A port of a display device.
    2. Plug in the USB Receiver
  2. Press and hold the AirPen's (VB-PEN-007) Power Button for three (3) seconds to begin pairing.
    3. Note: When in pairing mode, the LED Indicator will be flashing blue.
    Press and Hold the Power Button
  3. After successfully powering on and pairing the VB-PEN-007, the LED Indicator will be a steady blue.

Re-Pairing the AirPen (VB-PEN-007)

Retrieved from "https://manuals.viewsonic.com/index.php?title=VB-PEN-007_Initial_Setup&oldid=38287"