Revision as of 02:53, 4 January 2024

VB-PEN-007 Initial Setup

Charging the AirPen (VB-PEN-007)

Note: Fully charge the AirPen (VB-PEN-007) before its first use.

Connect the USB Type C end of the included USB cable to the Charging Port of the AirPen (VB-PEN-007).
Then connect the other end, the USB Type A, of the cable to a USB Type A port of a display or other power delivering device.
When charging, the LED Indicator will be a steady red. When fully charged, the VB-PEN-007 can provide four (4) hours of use.

Note: A short, 10 minute charge can provide one (1) hour of use.

Press and hold the AirPen's (VB-PEN-007) Power Button for three (3) seconds to begin pairing.

Note: When in pairing mode, the LED Indicator will be flashing blue.

After successfully powering on and pairing the VB-PEN-007, the LED Indicator will be a steady blue.

@@ Line 17: / Line 17: @@
 =Powering On and Pairing the AirPen (VB-PEN-007)=
+<ol><li>Plug the USB Receiver into a USB Type A port of a display device.</li>
+<div class="res-img">[[File:VB-PEN-007_Plug_USB_Receiver.png|Plug in the USB Receiver|400px]]</div>
+<li>Press and hold the AirPen's (VB-PEN-007) '''Power Button''' for three (3) seconds to begin pairing.</li>
+{{Note|When in pairing mode, the '''LED Indicator''' will be flashing blue.}}
+<div class="res-img">[[File:VB-PEN-007_Press_and_Hold_Power.png|Press and Hold the Power Button|400px]]</div>
+<li>After successfully powering on and pairing the VB-PEN-007, the LED Indicator will be a steady blue.</li></ol>
+=Re-Pairing the AirPen (VB-PEN-007)=