X100-4K Initial Setup

From ViewSonic User Guide Database
Revision as of 07:45, 3 September 2020 by Rob.vsi (talk | contribs) (→‎Mounting the Projector)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
Backtotop.svg

Choosing a Location - Projector Orientation

Personal preference and room layout will decide the installation location. Consider the following:

  • Size and position of your screen.
  • Location of a suitable power outlet.
  • Location and distance between the projector and other equipment.
Location Description
Front Table The projector is placed near the floor in front of the screen.
Front Ceiling The projector is suspended upside-down from the ceiling in front of the screen.
Rear Table[1] The projector is placed near the floor behind the screen.
Rear Ceiling[1] The projector is suspended upside-down from the ceiling behind the screen.
  1. 1.0 1.1 A rear projection screen is required.

Projection Dimensions

X100 Projection Dimensions.png
NOTE: (e) = Screen | (f) = Center of Lens

16:9 Image on a 16:9 Screen

(a) Screen Size (b) Projection Distance (c) Image Height (d) Vertical Offset
Minimum Maximum
in. cm in. cm in. cm in. cm in. cm
40 101.6 41.84 106.3 50.29 127.5 19.61 49.8 12.75 32.4
60 152.4 62.75 159.4 75.3 191.3 29.42 74.7 19.12 48.6
70 177.8 73.21 186 87.85 223.2 34.32 87.2 22.31 56.7
80 203.2 83.67 212.5 100.41 255 39.22 99.6 25.49 64.8
90 228.6 94.13 239.1 113 286.9 44.12 112.1 28.68 72.8
100 254 104.59 265.7 125.51 318.8 49.03 124.5 31.87 80.9
120 304.8 125.51 318.8 150.61 382.5 58.83 149.4 38.24 97.1
150 381 156.88 398.5 188.26 478.2 73.54 186.8 47.8 121.4
200 508 209.18 531.3 251.01 637.6 98.05 249.1 63.73 161.9
These figures are for reference purposes only. Please refer to the actual projector for the precise dimensions.

Mounting the Projector

NOTE: If you buy a third party mount, please use the correct screw size. Screw size can vary depending on the thickness of the mounting plate.
  1. To ensure the most secure installation, please use a ViewSonic® wall or ceiling mount.
  2. Ensure the screws used to attach the mount to the projector meet the following specifications:
  • Screw type: M6 x 8
  • Maximum Screw Length: 8 mm

X100 Mount.png

CAUTION
  • Avoid installing the projector near a heat source or air conditioner.
  • Keep at least a 10 cm (3.9 in.) gap between the ceiling and the bottom of the projector.