VA2247-mh Initial Setup

From ViewSonic User Guide Database
Revision as of 07:45, 12 July 2021 by Rob.vsi (talk | contribs) (Created page with "<noinclude> {{Sticky_Menu_Monitor_2.1_SU |1=VA2247-mh_Introduction |2=VA2247-mh_Initial_Setup |3=VA2247-mh_Connecting_Power_and_Devices |4=VA2247-mh_Adjusting_the_Viewing_Angl...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Stand Installation

VA2247-mh Stand Installation.png


Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.

Wall Mounting

Refer to the table below for the standard dimensions for wall mount kits.

For use only with a UL certified wall mount kit/bracket. To obtain a wall-mounting kit or height adjustment base, contact ViewSonic® or your local dealer.
Maximum Loading Hole Pattern (W x H) Interface Pad (W x H x D) Pad Hole Screw Specification & Quantity
14 kg 100 x 100 mm 115 x 115 x 2.6 mm Ø 5 mm M4 x 10 mm - 4 pieces
  1. Turn off the device and disconnect all cables.
  2. Place the device on a flat, stable surface with the scree facing down.
  3. Remove the stand.
  4. VA2247-mh Wall Mounting.png
  5. Attach the mounting bracket to the VESA mounting holes at the rear of the monitor. Then secure it with four (4) screws (M4 x 10 mm).
  6. VA2247-mh Wall Mounting VESA.png
  7. Follow the instructions that come with the wall mounting kit to mount the monitor onto the wall.

Using the Security Slot