Revision as of 09:26, 29 April 2020

Overview

Button	Icon	Description
Power		Turns the projector On or Off.
Source		Displays the input source selection bar.
Focus		Automatically focus the image. To manually adjust, press and hold the Focus button on the remote control for three (3) seconds.
Setting		Displays the Settings menu.
Audio Mode		Displays the speaker settings.
Bluetooth		View Bluetooth options.
Up/Down/Left/Right		Navigates and selects the desired menu items and makes adjustments.
Shuttle Wheel Left/Right
OK		Confirms the selection.
Return		Returns to the previous screen.
Home		Access the Home menu.
Volume Control		Increases/decreases the volume level or mutes/unmutes it.

To ensure proper function of the remote control follow the steps below:

The remote control must be held at an angle within 30° perpendicular to the projector’s IR remote control sensor(s).
The distance between the remote control and the sensor(s) should not exceed 8 m (26 ft.)

NOTE: Refer to the illustration for the location of the infrared (IR) remote control sensor(s).

Remove the battery cover from the bottom of the remote control by pressing the finger grip and sliding it across.
Remove any existing batteries (if necessary) and install two AAA batteries.
Replace the battery cover by aligning it with the base and pushing it back into position.

NOTE:

Avoid leaving the remote control and batteries in excessive heat or a humid environment.
Replace only with the same or equivalent type recommended by the battery manufacturer.
If the battery is drained or if you will not be using the remote control for an extended period of time, remove the battery to avoid damage to the remote control.
Dispose of used batteries according to the manufacturer’s instructions and local environment regulations for your region.

@@ Line 55: / Line 55: @@
 | Increases/decreases the volume level or mutes/unmutes it.
 |}
+=Effective Range=
+[[File:X10_remote_range.png|thumb| IR Receiver Location]]
+To ensure proper function of the remote control follow the steps below:
+# The remote control must be held at an angle within 30° perpendicular to the projector’s IR remote control sensor(s).
+# The distance between the remote control and the sensor(s) should not exceed 8 m (26 ft.)
+::<small>'''NOTE:''' Refer to the illustration for the location of the infrared (IR) remote control sensor(s).</small>
+=Replacing the Batteries=
+# Remove the battery cover from the bottom of the remote control by pressing the finger grip and sliding it across.
+# Remove any existing batteries (if necessary) and install two AAA batteries.
+# Replace the battery cover by aligning it with the base and pushing it back into position.
+[[File:X10_Remote_Battery.png|400px]]
+{{Note-yellow| '''NOTE:'''
+:* Avoid leaving the remote control and batteries in excessive heat or a humid environment.
+:* Replace only with the same or equivalent type recommended by the battery manufacturer.
+:* If the battery is drained or if you will not be using the remote control for an extended period of time, remove the battery to avoid damage to the remote control.
+:* Dispose of used batteries according to the manufacturer’s instructions and local environment regulations for your region.}}
 [[Category:X10-4K]]
 [[Category:X Series]]