LS901HD LS901-4K Mounting the Projector: Difference between revisions

Revision as of 01:24, 7 November 2024

Note: If you buy a third party mount, please use the correct screw size. Screw size can vary depending on the thickness of the mounting plate.

To ensure the most secure installation, please use a ViewSonic® wall or ceiling mount.
Make sure the screws used to attach the mount to the projector meet the following specifications:
- Screw type: M4 x 10
- Maximum Screw Length: 10 mm

CAUTION

Avoid installing the projector near a heat source or air conditioner.
Keep at least a 10 cm (3.9 in.) gap between the ceiling and the bottom of the projector.

@@ Line 5: / Line 5: @@
      <li> <translate>To ensure the most secure installation, please use a ViewSonic® wall or ceiling mount.</translate>
      </li>
-     <li>E<translate>nsure the screws used to attach the mount to the projector meet the following specifications:</translate>
+     <li><translate>Make sure the screws used to attach the mount to the projector meet the following specifications:</translate>
          <ul>
-             <li>S<translate>crew type: M4 x 10</translate></li>
+             <li><translate>Screw type: M4 x 10</translate></li>
-             <li>M<translate>aximum Screw Length: 10 mm</translate>
+             <li><translate>Maximum Screw Length: 10 mm</translate>
                  <div class="res-img">[[File:LS901HD_Mount.png|400px| <translate>Mounting points</translate> | alt= <translate>Mounting points</translate>]]</div>
              </li>