Rob.vsi at 03:32, 27 September 2024

2024-09-27T03:32:27Z

← Older revision		Revision as of 03:32, 27 September 2024
Line 106:		Line 106:
	</noinclude>		</noinclude>

	~~{{DISPLAYTITLE:AirPen Regulatory and Service Information}}~~
	{{#seo:		{{#seo:
	\|title=ViewBoard Accessories		\|title=ViewBoard Accessories

Rob.vsi at 03:53, 4 January 2024

2024-01-04T03:53:06Z

← Older revision		Revision as of 03:53, 4 January 2024
Line 105:		Line 105:
	''Please see'' <big>[[Customer_Service\|Customer Service]]</big>		''Please see'' <big>[[Customer_Service\|Customer Service]]</big>
	</noinclude>		</noinclude>



	{{DISPLAYTITLE:AirPen Regulatory and Service Information}}		{{DISPLAYTITLE:AirPen Regulatory and Service Information}}

	{{#seo:		{{#seo:
	\|title=ViewBoard Accessories		\|title=ViewBoard Accessories

Rob.vsi at 03:48, 4 January 2024

2024-01-04T03:48:25Z

← Older revision		Revision as of 03:48, 4 January 2024
Line 8:		Line 8:
	}}		}}
	</noinclude>		</noinclude>
			=Compliance Information=
			This section addresses all connected requirements and statements regarding regulations. Confirmed corresponding applications shall refer to nameplate labels and relevant markings on the unit.

			==FCC Compliance Statement==
			This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

			These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

			*Reorient or relocate the receiving antenna.
			*Increase the separation between the equipment and receiver.
			*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
			*Consult the dealer or an experienced radio/TV technician for help.

			'''Warning:''' You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

			==Industry Canada Statement==
			CAN ICES-003(B) / NMB-003(B)<br />
			{\| style="width:50%;"
			\|-
			\| AirPen
			\| VS19566<br />(VB-PEN-007)
			\|
			\| USB Receiver
			\| VS19567<br />(VB-PEN-007-2)
			\|-
			\| FCC ID:
			\| GSS-VS19566
			\|
			\| FCC ID:
			\| GSS-VS19567
			\|-
			\| IC ID:
			\| 4280A-VS19566
			\|
			\| IC ID:
			\| 4280A-VS19567
			\|}

			==FCC Radiation Exposure Statement==
			This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator & your body.

			==Validity of using the module certification==
			In the event that these conditions cannot be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization for this module in combination with the host equipment is no longer considered valid and the FCC ID of the module cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. Custom design antennas may be used, however the OEM installer must following the FCC 15.21 requirements and verify if new FCC approval will be necessary.

			==IC Warning Statement==
			This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.<br />

			Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : ( 1 ) l’appareil ne doit pas produire de brouillage, et ( 2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, méme si le brouillage est susceptible d’en compromettre le fonctionnement.

			==CE Conformity for European Countries==
			{\|
			\|-
			\| <div class="res-img">[[File:Ce-mark.png\|70px\|]]</div>
			\| style="width:90%;"\|The device complies with the EMC Directive 2014/30/EU, Low Voltage Directive 2014/35/EU and Radio Equipment Directive 2014/53/EU.<br />https://www.viewsonicglobal.com/public/products_download/safety_compliance/acc/VS19566_CE_DoC.pdf<br />https://www.viewsonicglobal.com/public/products_download/safety_compliance/acc/VS19567_CE_DoC.pdf
			\|}

			==The following information is only for EU-member states:==
			{\|
			\|-
			\| style="width:90%;"\|The mark shown to the right is in compliance with the Waste Electrical and Electronic Equipment Directive 2012/19/EU (WEEE). The mark indicates the requirement NOT to dispose of the equipment as unsorted municipal waste, but use the return and collection systems according to local law.
			\| <div class="res-img">[[File:WEEE_Logo.gif\|100px]]</div>
			\|}

			{{RoHS2_Compliance_Short}}

			==Indian Restriction of Hazardous Substances==

			<p>Restriction on Hazardous Substances statement (India). This product complies with the “India E-waste Rule 2011” and prohibits use of lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except for the exemptions set in Schedule 2 of the Rule.</p>

			{{Product_Disposal}}

			=Copyright Information=
			Copyright© ViewSonic® Corporation, 2023. All rights reserved.

			Macintosh and Power Macintosh are registered trademarks of Apple Inc.

			Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation in the United States and other countries.

			ViewSonic® and the three birds logo are registered trademarks of ViewSonic® Corporation.

			VESA is a registered trademark of the Video Electronics Standards Association. DPMS, DisplayPort, and DDC are trademarks of VESA.

			ENERGY STAR® is a registered trademark of the U.S. Environmental Protection Agency (EPA).

			As an ENERGY STAR® partner, ViewSonic® Corporation has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

			<b>Disclaimer:</b> ViewSonic® Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.

			In the interest of continuing product improvement, ViewSonic® Corporation reserves the right to change product specifications without notice. Information in this document may change without notice.

			No part of this document may be copied, reproduced, or transmitted by any means, for any purpose without prior written permission from ViewSonic® Corporation.

			VB-PEN-007_UG_ENG_1a_20231012
			<noinclude>
			=Customer Service=
			''Please see'' <big>[[Customer_Service\|Customer Service]]</big>
			</noinclude>

Rob.vsi: Created page with " {{Menu_VB-PEN-007 |1=VB-PEN-007_Introduction |2=VB-PEN-007_Initial_Setup |3=VB-PEN-007_Using_the_Pen |4=VB-PEN-007_Appendix |5=VB-PEN-007_Regulatory_and_Service_Information }} {{DISPLAYTITLE:AirPen Regulatory and Service Information}} {{#seo: |title=ViewBoard Accessories |title_mode=append |keywords=ViewBoard, AirPen, VB-PEN-007, Regulatory and Service Information |description=Regulatory and Service Information for the AirPen, VB-PEN-007. }}..."

2024-01-04T03:33:03Z

Created page with "<noinclude> {{Menu_VB-PEN-007 |1=VB-PEN-007_Introduction |2=VB-PEN-007_Initial_Setup |3=VB-PEN-007_Using_the_Pen |4=VB-PEN-007_Appendix |5=VB-PEN-007_Regulatory_and_Service_Information }} </noinclude> {{DISPLAYTITLE:AirPen Regulatory and Service Information}} {{#seo: |title=ViewBoard Accessories |title_mode=append |keywords=ViewBoard, AirPen, VB-PEN-007, Regulatory and Service Information |description=Regulatory and Service Information for the AirPen, VB-PEN-007. }}..."

New page

<noinclude>
{{Menu_VB-PEN-007
|1=VB-PEN-007_Introduction
|2=VB-PEN-007_Initial_Setup
|3=VB-PEN-007_Using_the_Pen
|4=VB-PEN-007_Appendix
|5=VB-PEN-007_Regulatory_and_Service_Information
}}
</noinclude>

{{DISPLAYTITLE:AirPen Regulatory and Service Information}}

{{#seo:
|title=ViewBoard Accessories
|title_mode=append
|keywords=ViewBoard, AirPen, VB-PEN-007, Regulatory and Service Information
|description=Regulatory and Service Information for the AirPen, VB-PEN-007.
}}

[[Category:VB-PEN-007]]

VB-PEN-007 Regulatory and Service Information - Revision history

Rob.vsi at 03:32, 27 September 2024

Rob.vsi at 03:53, 4 January 2024

Rob.vsi at 03:48, 4 January 2024