View source for TD2423d Initial Setup

<noinclude>
{{Sticky_Menu_Monitor_2.1
|1=TD2423d_Introduction
|2=TD2423d_Initial_Setup
|3=TD2423d_Connecting_Power_and_Devices
|4=TD2423d_Adjusting_the_Viewing_Angle
|5=TD2423d_Quick_Menu
|6=TD2423d_Hot_Keys
|7=TD2423d_On-Screen_Display_Menu
|8=TD2423d_On-Screen_Display_Menu_Tree
|9=TD2423d_Specifications
|10=TD2423d_Regulatory_and_Service_Information
}}
</noinclude>
=Stand Installation=
# Place the monitor on a flat, stable surface with the screen facing down.
# With one hand applying downward pressure on the monitor, carefully lift and extend the stand.
# Lift the device into its upright position on a flat, stable surface.

<gallery mode="traditional" heights=250px widths=250px>
TD2223_Stand_Install_01.svg|Extend the stand
TD2223_Stand_Install_02.svg|Lift into an upright position
</gallery>
:{{Note-yellow|Always place the device on a flat, stable surface. Failure to do so may cause the device to fall and damage the device and/or result in personal injury.}}

=Wall Mounting=
Refer to the table below for the standard dimensions for wall mount kits.

:{{Note-yellow|For use only with a UL certified wall mount kit/bracket. To obtain a wall-mounting kit or height adjustment base, contact ViewSonic® or your local dealer.}}

{| class="wikitable" style="text-align: center;" 
! style="background-color:#c41230; color:#ffffff;" | Maximum Loading
! style="background-color:#c41230; color:#ffffff;" | Hole Pattern (W x H)
! style="background-color:#c41230; color:#ffffff;" | Interface Pad (W x H x D)
! style="background-color:#c41230; color:#ffffff;" | Pad Hole
! style="background-color:#c41230; color:#ffffff;" | Screw Specification & Quantity
|-
|14 kg
|100 x 100 mm
|115 x 115 x 2.6 mm
|Ø 5 mm
|M4 x 10 mm - 4 pieces
|}

# Turn off the device and disconnect all cables.
# Place the device on a flat, stable surface with the screen facing down.
# Unscrew the attached stand and carefully remove it.
# Attach the mounting bracket to the VESA mounting holes at the rear of the monitor. Then secure it with four (4) screws (M4 x 10 mm).
# Follow the instructions that come with the wall mounting kit to mount the monitor onto the wall.
:<div class="res-img">[[File:TD2223_Wall_Mount.png|450px]]</div>
<noinclude>=[[Monitor_Security_Slot| Using the Security Slot]]=</noinclude>

[[Category:TD2423d]]